MacDon M105 Operator's Manual page 36

11. MD #166457
a. General hazard pertaining to machine operation
and servicing.
b. CAUTION
To avoid injury or death from improper or unsafe
machine operation:
i. Read the operator's manual and follow all
safety instructions.
manual, obtain one from your Dealer.
ii. Do not allow untrained persons to operate
the machine.
iii. Review safety
Operators annually.
iv. Ensure that all safety signs are installed
and legible.
v. Make certain everyone is clear of machine
before starting engine and during operation.
vi. Keep riders off the machine.
vii. Keep all shields in place and stay clear of
moving parts.
viii. Disengage header drive, put transmission
in Neutral and wait for all movement to stop
before leaving operator's position.
ix. Shut off the engine and remove the key from
ignition before servicing, adjusting, lubricating,
cleaning, or unplugging machine.
x. Engage locks to prevent lowering of header or
reel before servicing in the raised position.
xi. Use slow moving vehicle emblem and flashing
warning lights when operating on roadways
unless prohibited by law.
c. Run-over hazard.
d. WARNING
• Machine will move if steering wheel is turned
while engine is running.
• Steering response is opposite to what is
normally expected when backing up.
bottom of steering wheel in direction you want
to go.
• Always move ground speed lever to slow end of
range before shifting high-low speed control.
e. Run-over hazard.
f. Stop the engine and remove the key from ignition
before servicing, adjusting, lubricating, cleaning,
or unplugging the machine.
169890
SAFETY
If you do not have a
instructions with all
Turn
22
Figure 1.34: MD #166457
Revision A