Cutting Height; Return To Cut - MacDon M105 Operator's Manual

4.4.6 Cutting Height

Figure 4.75: Operator Console
A - Display
Cutting height is adjusted by raising or lowering the header with the HEADER UP (B) or HEADER DOWN (C)
switches on the ground speed lever (GSL).
The cab display module (CDM) indicates header height with a reading on the DISPLAY (A) lower line between 00.0
and 10.0, with 00.0 being on the ground.
Use DISPLAY SELECTOR switch (D) to display the current setting.

Return to Cut

The M-Series monitoring system will assist you in maintaining the desired cutting height with the RETURN TO CUT
feature. This feature can be turned OFF or ON with a switch on the cab display module (CDM).
The return to cut (RTC) feature provides preset cutting height and tilt angle settings for the header.
NOTE:
To enable the RTC header tilt feature, the optional hydraulic center-link and expansion module must be installed.
Refer to
7.1.12 Hydraulic Center-Link, page 339
If desired, the CDM can be programmed so only the cutting height feature is active. The unit will default to cutting
height only if no hydraulic center-link or expansion module is installed.
Refer to the following procedures:
•
Programming Return to Cut Feature, page 128
•
Using Return to Cut Feature, page 129
169890
OPERATION
B - Header Up
and
C - Header Down
7.1.10 Expansion Module, page
127
D - Display Selector
338.
Revision A