MacDon M105 Operator's Manual page 307

NOTE:
Image showing filter head removed to show component
clarity.
7. Remove gasket (C) from groove (B) in filter head (A).
Installing Return Filter
NOTE:
For filter specifications, refer to
page 200.
NOTE:
Image showing filter head removed to show component
clarity.
1. Clean the gasket groove (B) in the filter head (A).
2. Apply a thin film of clean oil to the filter gasket (C).
3. Install new gasket into the groove (B) in the filter
head (A).
4. Screw the new filter (D) onto the filter head until the
gasket contacts the filter.
5. Tighten filter an additional 3/4 turn by hand.
IMPORTANT:
Do NOT use a filter wrench to install oil filter.
Overtightening can damage gasket and filter.
6. Check hydraulic fluid levels. Refer to
Filling Hydraulic Oil, page
to
Lubricants, Fluids, and System Capacities, page
199.
169890
MAINTENANCE AND SERVICING
Filter Part Numbers,
Checking and
288. For capacity level, refer
Figure 5.182: Hydraulic System
Figure 5.183: Hydraulic System
Figure 5.184: Hydraulic System
293
Revision A