MacDon M105 Operator's Manual page 254

NOTE:
If replacing filter, refer to
1. Screw the new filter (A) onto the filter mount until the
gasket contacts the filter head.
2. Reconnect water in fuel (WIF) sensor (B).
3. Tighten the filter an additional 1/2 to 3/4 turn by hand.
IMPORTANT:
Do NOT use a filter wrench to install the filter.
Overtightening can damage the gasket and filter.
Removing Secondary Fuel Filter
1. Stop the engine and remove the key.
2. Open the hood, refer to
Position), page 203.
3. Clean around the secondary filter head (A).
4. Place a container under the filter to catch spilled fluid.
5. Remove filter (B) with a filter wrench.
6. Clean gasket mating surface.
Installing Secondary Fuel Filter
IMPORTANT:
Do NOT prefill filter with fuel. Prefilling can contaminate the fuel system.
NOTE:
If replacing filter, refer to
169890
MAINTENANCE AND SERVICING
Filter Part Numbers, page
5.4.3 Opening Hood (Highest
Filter Part Numbers, page
200.
Figure 5.83: Fuel System
Figure 5.84: Fuel System
200.
240
Revision A