MacDon M105 Operator's Manual page 322

Raising Caster Wheel (Formed and Forked)
This procedure is the same for forked and formed caster wheels.
DANGER
Stop engine and remove key from ignition before leaving operator's seat for any reason. A child or even a
pet could engage an idling machine.
1. Park windrower on level ground and block the
drive wheels.
2. Place the ground
N-DETENT (B), stop the engine, and remove the key.
3. Raise end of walking beam (A) using a suitable lifting
device capable of lifting 5000 lb (2268 kg) minimum
until the caster wheel assembly (B) is slightly off
the ground.
4. Place a jack stand beneath the walking beam and lower
the beam until resting on the stand.
169890
MAINTENANCE AND SERVICING
speed lever (GSL [A]) in
Figure 5.206: GSL Position
Figure 5.207: Caster Wheel Assembly
308
Revision A