Detaching An A-Series Header: Mechanical Center-Link - MacDon M105 Operator's Manual

13. Disconnect header
electrical harness (B). Refer to the auger header
operator's manual.
14. Slowly back windrower away from header.
15. Reinstall clevis pin (B) and secure with hairpin (A) in
header boot (C).
16. Repeat for the opposite side.

Detaching an A-Series Header: Mechanical Center-Link

WARNING
Stop engine, and remove key before making
adjustments to machine. A child or even a pet could
engage the drive.
1. Start engine and press HEADER UP button (A)
on ground speed lever (GSL) to raise header to
maximum height.
2. If one end of the header does NOT raise fully follow
these steps to rephase the cylinders:
a. Press and hold the HEADER UP (A) switch until
both cylinders stop moving
b. Continue to hold the switch for 3–4 seconds.
Cylinders are phased.
3. Stop engine and remove key.
169890
OPERATION
drive hydraulics (A) and
Figure 4.159: Header Drive Hydraulics
Figure 4.160: Header Boots
Figure 4.161: GSL
163
Revision A