MacDon M105 Operator's Manual page 120

7. Remove float pin from engaged position (A) and insert
in storage location (B). Secure with lynch pin.
8. Remove pins (A) from lower end of lift linkages.
NOTE:
Pins (A) are also used to secure weight box to
windrower linkage.
9. Release the safety props on the header lift cylinders.
(Refer to
4.4.1 Header Safety Props, page
10. Start engine and lower header down onto the
transport wheels.
11. Use the HEADER TILT switches to release load on the
cylinder if necessary.
12. Shut down engine and remove key from ignition.
169890
OPERATION
Figure 4.35: Lift Arms
117.)
Figure 4.36: Lift Arms
Figure 4.37: Ground Speed Lever (GSL)
A - Header Tilt Down
106
B - Header Tilt Up
Revision A