Engine Running, Header Engaged, Draper Header, Index Switch Off - MacDon M105 Operator's Manual

Display (Lower or Upper Line)
###### TOTAL ACRES
###### TOTAL HECT (if Metric)
##.## REEL RPM
##.## REEL SENSOR (Flashing)
##.# AUGER SPEED
#### KNIFE SPEED
#### KNIFE SENSOR (Flashing)
##.# HEADER HEIGHT
##.# HEADER SENSOR (Flashing)
##.# HEADER ANGLE
##.# ANGLE SENSOR
##.# VOLTS
FUEL|■■■■|■■■■|
ENGINE TEMP ### °F
ENGINE TEMP ### °C (if Metric)
SCROLL
SUB-MENU (Lower Line Only)
#### KNIFE SPEED
##.# AUGER SPEED
##.## REEL RPM
##.# HEADER HEIGHT

Engine Running, Header Engaged, Draper Header, Index Switch OFF

Scroll through display with cab display module (CDM) switch or ground speed lever (GSL) switch.
Display (lower or upper line)
#####.# ENGINE HRS
#####.# UNIT HRS
#####.# HEADER HRS
##.# ACRES/HOUR
##.# HECTARES/HOUR (if metric)
###.# SUB ACRES
###.# SUB HECTARES (if metric)
###### TOTAL ACRES
###### TOTAL HECT (if metric)
##.## REEL MPH or REEL RPM
##.## REEL KPH (if metric)
##.## REEL SENSOR (flashing)
##.# DRAPER SPEED
7. Optional: Available with Expansion Module installation – Whole Goods Bundle MD #B4666.
8. Optional: Available with Expansion Module Installation – Whole Goods Bundle MD #B4666.
169890
OPERATOR'S STATION
Description
Total area cut by machine.
Reel rotational speed. Optional
Sensor disabled.
Auger rotational speed (4.7–9.9).
Knife speed In strokes per minute. Optional
Sensor disabled.
Distance setting (00.0–10.0) between cutterbar and ground.
Sensor disabled.
Angle setting (00.0–10.0) header relative to ground. Optional
Sensor disabled.
Engine electrical system operating voltage.
Level of fuel in tank.
Engine coolant temperature.
Displays sub-menu after 2–3 Seconds. Press SELECT to cancel. Scroll
through sub-menu display with CDM switch.
Knife speed is optional
7
Reel rpm is optional .
7
Description
Total engine operating time.
Total windrower operating time.
Total header operating time.
Actual cutting rate in acres (hectares)/hour.
Area cut since last reset. To reset, display SUB ACRES on lower line,
and hold down program switch until display resets (5–7 seconds).
Total area cut by machine.
Reel peripheral speed in miles per hour or rpm. Optional.
Sensor Disabled.
Draper speed (0.0–10.0).
64
7
.
7
.
.
7
.
8
Revision A