MacDon M105 Operator's Manual page 257

7. Add some clean fuel to tank to flush out any
remaining contaminants.
8. Reattach fuel supply hose (A) to fitting.
clamp (B) and tighten.
NOTE:
Do NOT refill the fuel tank if you need to work on the
system. Refill it once work is completed. Refer to
Fuel Tank, page 92.
Fuel/Water Separator
A fuel water separator is incorporated into the primary fuel filter. The separator is equipped with a drain and with a
sensor that detects water in the fuel and alerts the Operator on the cab display module (CDM).
Refer to the following procedure to remove water from the fuel system:
•
Removing Water from Fuel System, page
Removing Water from Fuel System
Drain the water and sediment as follows from the separator daily, or at any time the cab display module (CDM)
water in fuel (WIF) light illuminates.
1. Stop the engine and remove the key.
2. Open the hood, refer to
Position), page 202.
3. Place a container under the filter (A) to catch
spilled fluid.
4. Turn drain valve (C) by hand 1-1/2 to 2 turns
counterclockwise until draining occurs.
5. Drain the filter sump of water and sediment until clear
fuel is visible.
6. Turn the valve clockwise to close the drain.
7. Dispose of fluid safely.
8. Close the hood, refer to
Position), page 203.
169890
MAINTENANCE AND SERVICING
Install
Filling
243.
5.4.1 Opening Hood (Lower
5.4.2 Closing Hood (Lower
Figure 5.90: Fuel System
Figure 5.91: Fuel System
243
Revision A