MacDon M105 Operator's Manual page 287

1. Shut down engine and remove key. Turn lights ON.
2. Loosen bolt (A) and nut (B) (located inside light /
mirror support).
3. Position light to desired position.
4. Tighten bolt (A) and nut (B).
Replacing HID Lamp (if Installed)
DANGER
Stop engine and remove key from ignition before leaving operator's seat for any reason. A child or even a
pet could engage an idling machine.
1. Shut down engine and remove key. Turn lights OFF.
NOTE:
Hold onto the handholds on the cab front corners
and stand on the header anti-slip strips, or stand on
the maintenance platform when accessing the HID
auxiliary lights.
2. Disconnect lamp connector (A) from electrical
harness (B).
169890
MAINTENANCE AND SERVICING
273
Figure 5.144: HID Auxiliary Lights
Figure 5.145: HID Auxiliary Light Harness
Revision A