Running Up Header - MacDon R113 Unloading And Assembly Instructions

10.16 Running up Header

Running up the header to ensure that everything is working as expected, and that the machine is ready for delivery to the
customer.
WARNING
• Ensure that bystanders remain at least 100 m (330 ft.) from the header while it is operating. Stones and other
objects can be ejected from the header with great force.
• Inspect the cutterbar area carefully for loose hardware. These objects can be ejected with great force when the
header is engaged, resulting in serious injury or damage.
• Cutterbar curtains reduce the potential for thrown objects. Always keep these curtains down when operating the
disc header. Replace the curtains if they become worn or damaged.
DANGER
Before investigating an unusual sound or attempting to correct a problem, shut off the engine, engage the parking
brake, and remove the key.
DANGER
Ensure that all bystanders have cleared the area.
NOTE:
Higher engine rpm may be required to engage the header. Do NOT exceed 1800 rpm.
1. Start the engine.
2. Set the header 152–305 mm (6–12 in.) above the ground and adjust the center-link to mid-position.
3. Run the machine slowly for 5 minutes, and watch and listen FROM THE OPERATOR'S SEAT for binding or
interfering parts.
4. Run the machine at operating speed for 15 minutes. Listen for any unusual sounds or abnormal vibration.
5. Perform the run-up check as listed on the Predelivery Checklist (the yellow sheet inside the back cover of this
instruction) to ensure the machine is field-ready.
6. Shut down the engine, and remove the key from the ignition.
7. Retain the Predelivery Checklist and this instruction for future reference.
262300
PERFORMING PREDELIVERY CHECKS
134
Revision A