Hydraulic Oil Cooler - MacDon M105 Operator's Manual

4. If necessary, add oil to maintain a level between the
LOW and FULL marks.
Refer to
Lubricants, Fluids, and System Capacities,
for hydraulic oil specifications and quantity.
page 199
NOTE:
When dipstick is showing LOW, approximately 1 US
gallon (4 liters) is required to reach the FULL mark.
IMPORTANT:
• Use good quality, prefiltered oil.
• Exercise care to prevent debris from falling into tank.
5. Reinstall dipstick and filler cap, and turn clockwise to
tighten/lock.
6. Close the hood. Refer to
Position), page 203.

Hydraulic Oil Cooler

The hydraulic oil cooler is located inside the cooling box behind the radiator.
It should be cleaned daily with compressed air. Refer to
169890
MAINTENANCE AND SERVICING
5.4.2 Closing Hood (Lower
Figure 5.175: Engine Hood
Figure 5.176: Checking Hydraulic Oil
Cleaning Cooler Box Components, page
289
252.
Revision A