Fuel System - MacDon M105 Operator's Manual

Fuel System

Removing and Installing Fuel Tank Vent Filter
The fuel tank is vented by a hose that is connected to the filler tube. The hose is connected to a filter that should
be changed annually.
Change the filter as follows:
DANGER
Stop engine and remove key from ignition before leaving operator's seat for any reason. A child or even a
pet could engage an idling machine.
WARNING
To avoid personal injury or death from explosion or fire, do NOT smoke or allow flame or sparks near
windrower when servicing.
1. Stop the engine and remove the key.
2. Open the hood. Refer to
Position), page 203.
3. Open the left cab-forward side maintenance platform.
Refer to
5.5.1 Opening Platform (Standard Position),
page 205.
4. Locate filter (A) on vent line against hydraulic
oil reservoir.
5. Release hose tension clamps (B) and slide away from
filter. Pull hoses off filter.
6. Position new filter through hole in frame and attach top
hose onto filter. IN marking should face down.
NOTE:
If filter has an arrow instead of an IN marking, arrow
should point up.
7. Attach lower hose to filter and secure both hoses with
tension clamps (B).
8. Close hood, refer to
Position), page 204.
169890
MAINTENANCE AND SERVICING
5.4.3 Opening Hood (Highest
5.4.4 Closing Hood (Highest
Figure 5.78: Fuel System
237
Revision A