Header Position Switches
Press and hold switch at location shown to move header
up or down and to change the angle of the header relative
to the ground. Release switch at desired position.
NOTE:
Refer to the section in this manual that is specific to your
header for detailed switch operating modes.
Reel Speed Switches
Press and hold switch (A) to increase the reel speed. Press
and hold switch (B) to decrease the reel speed. Release
switch at desired speed.
NOTE:
Auger speed is adjusted proportionately when reel speed
is changed.
For further details, refer to
for D-Series headers or
A-Series headers.
169890
OPERATOR'S STATION
4.6.6 Reel Speed, page 169
4.7.2 Reel Speed, page 181
Figure 3.40: Ground Speed Lever
A - Header Down
C - Header Up
for
Figure 3.41: Ground Speed Lever
A - Fast
59
B - Header Tilt Down
D - Header Tilt Up
B - Slow
Revision A