10. Disconnect reel hydraulics (A) from header and
store on bracket at windrower left cab-forward side.
Refer to the draper header operator's manual for
further information.
11. Loosen nut (A) and rotate barrel (B) to relieve load
on link.
12. Remove cotter pin on clevis pin (D) and remove the pin
(C) to disconnect from windrower. Reinstall clevis pin
(C) in header.
13. Tighten nut (A) against barrel.
hammer is sufficient.
14. Reinstall pin (A) into header leg and secure with a
hairpin (B).
4.5.3 Attaching an A-Series Header
Refer to the procedure that is appropriate for the center-link installed on the windrower:
•
Attaching an A-Series Header: Hydraulic Center-Link, page 149
•
Attaching an A-Series Header: Mechanical Center-Link, page 154
169890
OPERATION
A slight tap with a
148
Figure 4.120: Reel Hydraulics
Figure 4.121: Mechanical Center-Link
Figure 4.122: Header Leg
Revision A