MacDon M105 Operator's Manual page 176

8. To disengage safety props and for storage, turn
lever (A) away from header to raise safety prop
until lever locks into vertical position.
opposite cylinder.
CAUTION
Check to be sure all bystanders have cleared the area.
9. Start engine, choose a level area, and lower header to
the ground.
10. Activate HEADER
ground speed lever (GSL) to release load on
center-link cylinder.
11. Stop engine, and remove key from ignition.
12. Lift hook release (C) and lift hook (B) off header pin.
NOTE:
If optional center-link self-alignment kit is installed, lift
release (C), and then operate the link lift cylinder with
REEL UP switch on GSL to disengage the center-link
from the header.
169890
OPERATION
Repeat for
TILT cylinder switch
Figure 4.156: Safety Props
on
Figure 4.157: GSL
A - Header Tilt Up
Figure 4.158: Hydraulic Center-Link
162
B - Header Tilt Down
Revision A