Operating With An A-Series Header; Auger Speed; Auger Speed On A30-D Headers - MacDon M105 Operator's Manual

4.7 Operating with an A-Series Header

The M105 is factory-equipped to run an A-Series Auger Header.

4.7.1 Auger Speed

This feature requires that the optional expansion module (MD #B4666) be installed, either at the factory or at your
MacDon Dealer.

Auger Speed on A30-D Headers

On A30-D Auger Headers, the auger speed is fixed to the knife speed.
NOTE:
Auger speed can be independently changed from the knife speed by changing the auger drive sprocket. Refer
to the A30-D and A40-D Pull-Type Mower Conditioner and Self-Propelled Auger Header Operator's Manual
(MD #169000).
Figure 4.187
A - Display
D - Auger Slow
Display the auger speed as follows:
1. Engage header.
2. Set HEADER INDEX switch (B) to OFF
3. On ground speed lever (GSL), press DISPLAY SELECTOR switch (E) for ##.# AUGER SPEED
##.# = 00.0–99.0
4. Press FAST (C) or SLOW (D) on CDM until desired auger speed is displayed at (A).
169890
OPERATION
B - Header Index Switch
E - Display Selector
179
C - Auger Fast
D - Auger Slow
Revision A