MacDon M105 Operator's Manual page 124

27. If the tow-bar (A) is TOO CLOSE to the windrower:
a. Remove pin (B), lower the drawbar support (C)
until the tow-bar clevis aligns, and then install the
drawbar pin (D).
b. Start engine, and gently drive the windrower
forward until the drawbar support pivots up to
transport position.
c. Stop engine, and remove key.
d. Reinstall pin (B).
28. Connect safety chain (A) through the slot in the
drawbar support (B), and securely attach the hook (C)
to the chain. Leave enough slack to allow the hitch
to pivot.
169890
OPERATION
Figure 4.45: Towing Components
Figure 4.46: Towing Components
110
Revision A