Programming Guidelines - MacDon M105 Operator's Manual

NOTE:
Contact your MacDon Dealer for information regarding software updates to the electronic modules. Your Dealer
will have the necessary interface tools and access to the latest software upgrades.
Proceed as follows to program the CDM:
IMPORTANT:
Header must be attached to the windrower so that the CDM can detect the type of header (Header ID) and
adjust the programming mode accordingly.
NOTE:
Pressing PROGRAM at any time will cancel the programming mode/menus and return back to the main operating
displays. For detailed programming menu selection, refer to
1. Turn ignition key to RUN or start the engine.
2. On CDM, press PROGRAM and SELECT to enter programming mode.
3. Press SELECT. WINDROWER SETUP? with header width displayed on upper line.
4. Press left or right arrow to change value on lower line.
5. Press SELECT to advance to the next L1 item and press arrow keys to change values.
6. Set the following functions:
NOTE:
The following can be set by the Dealer provided that the header is installed and other information needed
is available.
• TILT CYL INSTALLED?
• DISC BLK INSTALLED?
• HDR CUT WIDT?
• HAY CONDITIONER?
• SET TIRE SIZE?
7. Press PROGRAM to exit programming mode when finished entering values.

Programming Guidelines

Use the following guidelines when programming the cab display module (CDM):
1. The monitoring system requires programming for each header, and the HEADER MUST BE ATTACHED TO
THE WINDROWER so that the CDM recognizes the type of header.
2. Programming the system may be accomplished with or without the engine running.
• If the engine is running, the transmission must be in Neutral (GSL in N-DETENT).
• If the engine is not running, the ignition must be turned to RUN.
3. The system only needs to be programmed once for each header. Most functions are preset at the factory but
the Operator can make changes later on to suit windrowing conditions or modifications to the machine.
4. Input values for the windrower are provided in this manual, and values for the header functions are in the
operator's manual for the applicable header.
169890
OPERATOR'S STATION
Detailed Programming Menu Flow Chart, page
71
72.
Revision A