MacDon M105 Operator's Manual page 247

7. Clean the inside of the canister housing and end cap
carefully. Dirt left in the air cleaner housing may be
harmful to your engine.
• Remove hardened dirt ridges wherever filter gaskets
contact the cleaner housing.
• Clean the gasket sealing surfaces of the housing.
An improper gasket seal is one of the most common
causes of engine contamination.
• Wipe every surface
water-dampened cloth.
• Check it visually to make sure it is clean before
putting in a new element.
8. Check for uneven dirt patterns on your old element.
Your old element is a valuable clue to potential dust
leakage or gasket sealing problems. A pattern on the
element clean side is a sign that the old element was
NOT firmly sealed or that a dust leak exists.
• Press on the fresh gasket to see if it springs back.
• Check the gasket for correct sizing. On a radial seal
element the gasket surface is the inside diameter of
the open end cap.
• Make sure the gasket is seating evenly. If the gasket
is not forming a perfect seal, you will NOT have
protection.
• Ensure the sealing surface in the housing is clean,
and the filter element is the correct model number.
It may be too short for the housing.
• Identify and rectify the cause of any leaks before
replacing the filter element.
9. If required, also change the secondary filter. Refer
to
Removing and Installing Secondary Air Filter, page
236.
Installing Primary Air Filter
NOTE:
If replacing air filter, refer to
200.
169890
MAINTENANCE AND SERVICING
clean with a
Filter Part Numbers, page
clean,
233
Revision A