MacDon M105 Operator's Manual page 149

14. Remove clevis pin from storage position (B) in linkage
and insert in hole (A) to engage float springs. Secure
with hairpin.
15. Disengage safety prop by turning lever (A) downward
to release and lower stop until lever locks into
vertical position.
16. Repeat for opposite safety prop.
CAUTION
Check to be sure all bystanders have cleared the area.
17. Start engine and activate HEADER DOWN switch (A)
on GSL to lower header fully.
18. Stop engine and remove key.
169890
OPERATION
Figure 4.87: Header Lift Linkage
Figure 4.88: Cylinder Stop
Figure 4.89: GSL
135
Revision A