MacDon M105 Operator's Manual page 374

Codes
E41
E42 E142 REEL P4D
REEL UP/DOWN P4B
E43 E143
E44
E45
E46 SENSOR VOLTS HIGH
SENSOR VOLTS LOW
E47
E48
E49
E50 BATT+ OUT OF RANGE
E65 KNIFE OVERLOAD
E66 ##.# LOW VOLTS
E67 TRANS OIL PRESSURE
E68 TRANS Temp
E69
E70
E71
LOW HYDRAULIC OIL
E72 ##.# HIGH VOLTS
E101 SPI ERROR
E102 CAN ERROR
E103 EEPROM READ ERROR
E104 EEPROM WRITE ERROR
E105 TEMP SENSOR ERROR
169890
CAB DISPLAY MODULE (CDM) ERROR CODES
CDM Display
Error codes E52 to E64 not allocated
Error codes E73 to E100 not allocated
Reel fore / aft solenoid P4D (V4D) fault detected
Reel up / down solenoid P4B (V4B) fault detected
WCM's 9V Sensor voltage output high. (wire 5019)
WCM's 9V Sensor voltage output low. (wire 5019)
System voltage above 15.5 VDC.
Low knife speed detected (less than programmed overload
speed in CDM)
Low system voltage <11.5 VDC
Supercharge pressure low (switch 208 on hydraulic
schematic)
Oil Tank temp >221°F. / 105°C.
Low hydraulic oil level sensor tripped. (switch 225 on
hydraulic schematic)
System voltage above 15.5 VDC
J1939 Can Error
J1939 Can Error
Internal Error
Internal Error
Internal Temperature Sensor Error.
360
Description
Revision A