Draper Header Case Drain Kit; Draper Header Reel Drive And Lift Plumbing; Engine Block Heater; Engine Fan Air Baffle - MacDon M105 Operator's Manual

OPTIONS AND ATTACHMENTS

7.1.6 Draper Header Case Drain Kit

The Draper Header Case Drain kit must be installed when attaching a MacDon D50, D60, or D65 draper header
with an upper cross auger (UCA) but without double draper drive. Case Drain Kit (MD #B5842) is NOT required for
double draper drive headers equipped with kits (MD #B5606) and (MD #B5653).
MD #B5842

7.1.7 Draper Header Reel Drive and Lift Plumbing

Base kit required to run draper header. Includes draper header reel drive and lift plumbing (less valve) and reel
fore-aft hydraulics.
NOTE:
If the last digit of windrower code is B, this bundle is already installed.
MD #B5577
Includes Instruction MD #169537.

7.1.8 Engine Block Heater

Contact your nearest Cummins Engine Distributor, and provide your engine model and serial numbers to ensure
the proper heater is supplied.
7.1.9 Engine Fan Air Baffle
Prevents the windrow from being disturbed by engine cooling fan air blast.
MD #B5440
Instruction MD #169443 is included with the bundle

7.1.10 Expansion Module

Allows electronic monitoring of header knife speed, reel speed, and header angle. Also required for indexing reel
speed to ground speed. The windrower must be equipped with a hydraulic center-link (MD #B4650 and #B5269)
for header angle sensing: the header must be equipped with knife speed and reel speed sensors.
MD #B4666
Instruction MD #169392 is included with the bundle

7.1.11 HID Auxiliary Lighting

Provides additional field lighting. The kit includes two cab-mounted high intensity discharge (HID) lamps and
installation instructions.
MD #B5596
Instruction MD #169621 is included with the bundle
338
169890 Revision A