MacDon M105 Operator's Manual page 180

11. Loosen nut (A) and rotate barrel (B) to relieve load
on link.
12. Remove cotter pin (D) on clevis pin (C) and remove pin
to disconnect from header.
13. Reinstall clevis pin in header.
14. Disconnect header
electrical harness (B). Refer to the auger header
operator's manual.
15. Slowly back windrower away from header.
16. Reinstall clevis pin (B) and secure with hairpin (A) in
header boot (C).
17. Repeat for the opposite side.
169890
OPERATION
drive hydraulics (A)
Figure 4.167: Mechanical Center-Link
and
Figure 4.168: Header Drive Hydraulics
Figure 4.169: Header Boot
166
Revision A