MacDon M105 Operator's Manual page 268

6. Clean radiator (D) through access holes in cooling box
with compressed air.
7. Clean oil cooler / air conditioning condenser (A),
charge air cooler (E), fuel cooler (B), and cooling
box (C) with compressed air.
8. Inspect all lines and coolers for evidence of leaks
and damage.
9. Slide oil cooler / air conditioning condenser (A) back
into cooling box (C).
10. Close side access door and lock with lever.
11. Close access door on top of the cooling box and secure
with wing nut.
12. Close cooler box screen. Refer to
Screen, page 255.
Adjusting Screen Cleaner Duct to Screen Clearance
Check clearance between trailing edge of screen cleaner
duct (A) and screen. It should be 3/64–5/16 in. (1–8 mm)
at all locations when rotating.
NOTE:
Screen cleaner ducts rotate counterclockwise and may
touch screen as long as it continues to rotate.
If necessary, adjust clearance as follows:
1. Open the hood. Refer to
Position), page 202.
2. Loosen nut (B) on motor support (C).
3. Move support in or out until duct is 3/32–1/4 in.
(2–6 mm) from screen near the center.
4. Retighten nut (B).
5. Loosen the two motor mount bolts (D).
6. Move motor/duct assembly (E) to obtain 3/64–5/16 in.
(1–8 mm) gap to screen at full rotation of the duct.
7. Retighten nuts (D) on motor mount.
8. Close the hood. Refer to
Position), page 203.
169890
MAINTENANCE AND SERVICING
Closing Cooler Box
5.4.1 Opening Hood (Lower
5.4.2 Closing Hood (Lower
Figure 5.110: Engine Cooling System
Figure 5.111: Engine Cooling System
254
Revision A