MacDon M105 Operator's Manual page 119

Converting from Field to Transport Mode
DANGER
Stop engine and remove key from ignition before leaving operator's seat for any reason. A child or even a
pet could engage an idling machine.
DANGER
To avoid bodily injury from fall of raised header, always engage safety props when working on or around
raised header, and before going under header for any reason.
1. Set header on the ground (field position).
2. Disconnect the following hydraulic and electrical
connections:
a. Left Side – Store hydraulic hoses and electrical
cable into the storage position. Refer to header
operator's manual.
b. Right Side – Release the multi-link and place
into storage on windrower.
operator's manual.
3. Retrieve temporary lift pin from storage location on
weight box and install into rear hole (A) at the top
of the lift arms. This provides additional lift height for
transport wheel deployment.
CAUTION
Check to be sure all bystanders have cleared the area.
4. Raise header to full height and stop engine.
5. Engage safety props on lift cylinders. Refer to
Header Safety Props, page
6. Deploy header slow speed transport system. Refer to
header operator's manual.
169890
OPERATION
Refer to header
4.4.1
117.
105
Figure 4.33: Lift Linkage
Figure 4.34: Header in Transport Mode
Revision A