Chapter 5: Attaching Rotary Disc Header To Windrower; Attaching Header To M2 Series Windrower - MacDon R113 Unloading And Assembly Instructions

Chapter 5: Attaching Rotary Disc Header to Windrower

The procedure for attaching a rotary disc header to a windrower varies depending on the windrower model and how that
windrower is equipped.
Proceed to the procedure that is suitable for your windrower:
•
5.1 Attaching Header to M2 Series Windrower, page 35
•
5.2 Attaching Header to M1 Series Windrower, page 43
• 5.3 Attaching Header to M155, M155E4, or M205 Windrower – Hydraulic Center-Link with Self-Alignment, page 50
• 5.4 Attaching Header – Hydraulic Center-Link without Self-Alignment, page 56

5.1 Attaching Header to M2 Series Windrower

The R113 SP is compatible with the M2170 and M2260 Windrowers, but not the M2170NT Windrower.
DANGER
To prevent bodily injury or death from the unexpected start-up or fall of a raised machine, always stop the engine and
remove the key before leaving the operator's seat, and always engage the safety props before going under the
machine for any reason.
DANGER
Ensure that all bystanders have cleared the area.
1. Shut down the engine, and remove the key from the ignition.
2. Remove hairpin (A) from clevis pin (B), and remove the pin
from header support (C). Repeat this step on the other side
of the header.
3. Start the engine.
262300
Figure 5.1: Header Support
35
C
B
A
Revision A