Table of Contents
Advertisement
Basic Setup
Initialization
When the Titanium software is started, it verifies communication and status of the various sub-
systems: laser, scanning system, etc. If Titanium has been started following a printer power
cycle, this process may take up to 2 minutes. Titanium will report sub-system verification
progress. If the platform and recoater positions are unknown, you will be asked to initialize the
system. Acknowledging this request will send the platform and recoater to their home
positions.
Neo450 Network Connection
The Neo450 is equipped with an on-board ethernet switch. The switch links the application PC
and on-board camera to the LAN port at rear of printer. Where possible the Neo450 should be
connected via the LAN port (wired connection). Upon connection to a LAN the Neo450 PC can
be connected by the network administrator.
The on-board camera should also be connected with a fixed IP address.
A network and Internet connection will be required for certain functions, including but not
limited to:
•
Remote diagnosis
•
Remote monitoring
•
Webcam access
•
Process update email facility
Please contact Stratasys for more details on network connection options.
The Neo450 conforms to the following standards:
Ethernet
•
IEE 802.3
•
IEEE 802.3u
•
IEEE 802.3ab
Caution
Windows has been configured for reliable Neo operation.
Modification of Windows configuration should be avoided.
No modification to windows configuration should be made, locally or via group
policies, to the following:
•
Power and Screen Options
•
Fast Start-up
•
Windows Updates
© Copyright 2022 Stratasys. All rights reserved.
Initialization
Page 31
Advertisement
Table of Contents
