Setting The Ip Address - Stratasys Fortus 360mc User Manual
3d production system
Hide thumbs
Also See for Fortus 360mc:
- Service manual (444 pages) ,
- Manual (162 pages) ,
- User manual (124 pages)
Table of Contents
Advertisement
SETTING THE IP ADDRESS
1.
Power up the system, see
2.
From the Ready screen, select
3.
Select
Administration
4.
Select
Network Configuration
5.
Choose
or
YES
6.
If the
Dynamic IP
Select
•
erase incorrect entries.
•
Select
•
Select
Note: See your system administrator if you do not know the IP, Netmask, or
Gateway address.
7.
Choose
or
YES
"Powering Up the System" on page
Maintenance
Build Job..
Operator Control..
Modeler Status..
>Maintenance..
and press ENTER.
Modeler Default..
>Administration..
Reboot system..
and press ENTER.
>Network Configuration..
Receive Software Upgrade or Code..<E>
Field Service..
for the
NO
Dynamic IP
Dynamic IP: YES <E>
UpnP: ON <E>
*Configure Static Network Address
Dynamic IP: NO <E>
UpnP: ON <E>
>Configure Static Network Address
is set to
, select
NO
and enter the address using the keypad. Press ENTER. You can use the DEL key to
IP
(Netmask) and enter the address. Press ENTER.
MASK
(Gateway) and enter the address. Press ENTER.
GW
>IP
:
[172.16.70.10]
MASK:
(.none found)
GW
:
[172.16.100.1]
for the
.
NO
UPnP
and press ENTER.
| *Tips: Model T16
| *
Support T16
password:
.
Configure Static Network Address
7
31.
, then:
Advertisement
Table of Contents
