OVEN DOOR CAMERA
Required Tools
3 mm hex wrench
•
Removing the Oven Door Camera
Note: Do not touch the camera lens. If necessary, wipe the camera lens with a
clean microfiber cloth.
1.
Power OFF the printer. See
2.
Open the oven door.
3.
Using a 3mm hex wrench, remove the camera assembly mounting screw (1) through the hole in
the top of the oven door. See
4.
Gently move the camera assembly out a small distance and disconnect the cable on the back of
the camera.
5.
Remove the camera assembly from printer. See
Figure 7-36:
"Powering Off" on page
Figure
Camera Assembly Mounting Screw Location
169.
7-36.
Figure
7-36.
195