Table of Contents
Advertisement
Customer Replaceable Units
Oven Door Camera
Required Tools
•
3 mm hex wrench
Removing the Oven Door Camera
1. Power OFF the printer. See
2. Open the oven door.
3. Using a 3mm hex wrench, remove the camera assembly mounting screw (1) through the
hole in the top of the oven door. See
4. Gently move the camera assembly out a small distance and disconnect the cable on the
back of the camera.
5. Remove the camera assembly from printer. See
Note:
Do not touch the camera lens. If necessary, wipe the camera lens with a clean
microfiber cloth.
Figure 38: Camera Assembly Mounting Screw Location
© Copyright 2020 Stratasys. All rights reserved.
"Powering Off" (page
Figure 38 (page
Figure
Oven Door Camera
159).
185).
38.
Page 185
Advertisement
Table of Contents
