Customer Replaceable Units
6. Remove the blower assembly from the printer. See
Installing Oven Blower Assembly
1. Using a 3 mm hex wrench, reinstall the blower assembly mounting screws (5). Torque to 13
in-lbs. See
2. Make sure the blower motor cable is routed properly and secured with tie wraps.
3. Reconnect the fan blower motor cable connector to the I/O board (J39 - right blower, J37 -
left blower).
4. Reinstall the side panels. See
5. Reinstall the rear panel. See
Oven Door Gasket
Required Tools
•
Screwdriver or similar instrument
Note:
Right side oven blower shown only. The left side blower procedure is identical to the
right.
Figure 30: Right side blower assembly mounting screw locations
Figure 30 (page
© Copyright 2020 Stratasys. All rights reserved.
177).
"Installing the Side Panels" (page
"Installing the Rear Panel" (page
Oven Door Gasket
Figure 30 (page
177).
164).
161).
Page 177