Oven Door Gasket - Stratasys F170 User Manual
F123 series shared office 3d printers
Hide thumbs
Also See for F170:
- Operation and maintenance manual (91 pages) ,
- Site preparation manual (22 pages)
Table of Contents
Advertisement
OVEN DOOR GASKET
Required Tools
Screwdriver or similar instrument
•
Removing the Oven Door Gasket
1.
Power OFF the printer. See
2.
Open the oven door.
3.
Extract the gasket pins out of the holes around the entrance to the oven enclosure.
See
Figure
7-30.
4.
Pull the ends of the gasket out of the hole below the entrance to the oven enclosure.
See
Figure
7-30.
5.
Remove the oven gasket from the printer.
Figure 7-30:
Installing the Oven Door Gasket
1.
Insert the gasket pins into the holes around the perimeter of the entrance to the oven enclosure.
2.
Use a screwdriver or similar instrument to poke the ends of the gasket into the hole below the
entrance to the oven enclosure.
3.
Close the oven door.
"Powering Off" on page
Oven Door Gasket Detail (door removed for clarity)
169.
188
Advertisement
Table of Contents
