Rear Panel - Stratasys F170 User Manual

REAR PANEL

Required Tools
3 mm hex wrench
•
Removing the Rear Panel
Removal of the rear panel requires the removal of the AC power cord. Do not
install the AC power cord with the back panel removed.
1. Power OFF the printer, see
2. Using a 3 mm hex wrench, remove the rear panel mounting screws (16). See
3. The rear panel has brackets that allow it to hang on the printer frame. Remove the rear panel by
lifting upward and pulling away from the printer.
Figure 7-11: Rear Panel Mounting Screw Locations
Hanging Bracket
Installing the Rear Panel
1. Insert the rear panel hanger brackets into the notches in the side panels. See
2. Align the rear panel with the mounting holes in the frame. See
3. Using a 3 mm hex wrench, loosely install the rear panel mounting screws (16). See
4. Tighten the rear panel mounting screws (16).
"Powering Off" on page
170
169.
Figure 7-11.
Figure 7-11.
Mounting Screws
Figure 7-11.
Figure 7-11.