Customer Replaceable Units
Rear Panel
Required Tools
•
3 mm hex wrench
Removing the Rear Panel
1. Power OFF the printer, see
2. If present, disconnect the network cable from the Ethernet port.
3. Using a 3 mm hex wrench, remove the rear panel mounting screws (10). See
Figure 16 (page
4. The rear panel has formed tabs that allow it to hang on the printer frame. Remove the rear
panel by lifting upward and pulling away from the printer.
Installing the Rear Panel
1. Insert the rear panel formed tabs into the slots in the side and cover panels. See
Figure 16 (page
2. Align the rear panel with the mounting holes in the frame. See
3. Using a 3 mm hex wrench, loosely install the rear panel mounting screws (10). See
Figure 16 (page
Note:
Removal of the rear panel requires the removal of the AC power cord. Do not install
the AC power cord with the back panel removed.
161).
Figure 16: Rear Panel Mounting Screws
Formed Tab (4)
161).
161).
© Copyright 2020 Stratasys. All rights reserved.
"Powering Off" (page
159).
Figure 16 (page
Rear Panel
161).
Page 161