10 Install, update, restart, and other configuration
10.6 Reset user data
10.6 Reset user data
Overview
We recommend to perform a reset user data:
Procedure
Use the following procedure to reset the system settings:
226
•
when you want to reset the RAPID in the system.
•
when you want to restore the system to its original state by resetting RAPID
and system parameters.
•
when you want to remove the user configured safety settings and load the
default safety settings.
1 On the start screen, tap Settings, and then Backup & Recovery.
2 On the left sidebar tap Reset user data.
3 Select one of the following reset data options:
•
Reset RAPID: To reset the RAPID data of the loaded system.
•
Reset RAPID and System Parameters: To restore the system to its
original state by resetting the RAPID and system parameters.
•
Reset safety setting: To remove the user configured safety settings
and load the default safety settings.
4 Tap Reset.
A confirmation message is displayed.
5 Tap OK.
The controller is restarted and the system is updated according to the selected
reset data settings.
© Copyright 20192020 ABB. All rights reserved.
Operating manual - OmniCore
3HAC065036-001 Revision: E