Locking And Unlocking Operating Modes - ABB OmniCore S Series Operating Manual

3.3 Locking and unlocking operating modes

Introduction
It is possible to restrict an unauthorized change in operating mode by locking it.
This is done by configuring a temporary or permanent PIN-code.
The option for configuring a temporary PIN-code is automatically enabled if a
permanent PIN-code is not configured. While an operator can configure a temporary
PIN-code, the permanent PIN-code is configured by the user with the Key-less
mode selector grant.
Configuring a temporary PIN-code
Use the following procedure to configure a temporary PIN-code:
Once a temporary PIN-code is enabled, the user must provide the correct PIN-code
to change the operating mode. For more details, see
on page
Operating manual - OmniCore
3HAC065036-001 Revision: E
1 On the FlexPendant status bar, tap the QuickSet button.
The Control Panel window is displayed.
2 In the Mode section, tap the Lock button.
The Mode Selector PIN-code window is displayed.
xx2000000187
3 Tap a 4 digit PIN-code on the number pad.
4 Tap OK.
The operating mode is locked.
59.
Note
Since the temporary PIN-code is reset every time the operator unlocks it, this
procedure must be repeated every time to set a temporary PIN-code.
© Copyright 20192020 ABB. All rights reserved.
3 OmniCore controller operating modes
3.3 Locking and unlocking operating modes
Unlocking the operating mode
Continues on next page
57