6.3.2 Handling of modules
Overview
This section details how to handle program modules. i.e.:
Creating a new module
This section describes how to create a new module.
File format for modules
Loading an existing module
This section describes how to load an existing module.
Operating manual - OmniCore
3HAC065036-001 Revision: E
•
create a new module
•
load an existing module
•
save a module
•
rename a module
•
delete a module
1 On the start screen, tap Code, and then select Modules from the menu.
2 On the Context menu, tap New Module.
3 In the Create New Module window, enter a Module Name, and select if
Module Type should be Program or System. Tap Apply.
Note
How to later switch between these types is detailed in section
type of module on page
The module is created and displayed in the Modules section.
Note
In RobotWare 7.0 and earlier, the formats were .mod and .sys. When loading
these in a RobotWare 7.1 controller or later using RobotStudio, they are
automatically converted when saved. Note that the files must be converted, not
just renamed.
To convert a file manually, the file must be saved as UTF-8 without BOM (Byte
Order Mark).
1 On the start screen, tap Code, and then select Modules from the menu.
2 On the Context menu, tap Load Module.
© Copyright 20192020 ABB. All rights reserved.
6 Programming and testing
95.
6.3.2 Handling of modules
Changing
Continues on next page
93