Setup Stationary Work Object - ABB OmniCore S Series Operating Manual

6 Programming and testing

6.7.8 Setup stationary work object

6.7.8 Setup stationary work object
Make a work object robot held
Use the following procedure to make a workobject stationery:
144
1 On the start screen, tap Calibrate, and then select Workobject from the
menu.
2 Tap the work object you want to make stationery.
The Edit Workobject page is displayed.
3 Tap Value.
The data that defines the work object appears.
4 Set robhold to On (=TRUE).
5 Tap Save to use the new setup, Cancel to leave the work object unchanged.
© Copyright 20192020 ABB. All rights reserved.
Operating manual - OmniCore
3HAC065036-001 Revision: E