6.10.5 Service Information System service routine
When to use this service routine
ServiceInfo is a service routine based on Service Information System, SIS, a
software function which simplifies the maintenance of the robot system. It
supervises the operating time and mode of the robot, and alerts the operator when
a maintenance activity is scheduled.
ServiceInfo
Maintenance is scheduled by setting the system parameters of the type SIS
Parameters.
All system parameters are described in Technical reference manual - System
parameters. More details about SIS is described in Operating manual - Service
Information System.
Supervised functions
The following counters are available:
Counters are reset when maintenance has been performed.
The counter status is displayed after running the ServiceInfo routine for
maintenance. Status OK indicates that no service interval limit has been exceeded
by that counter. Status NOK indicates that service interval limit has been exceeded
by that counter.
Operating manual - OmniCore
3HAC065036-001 Revision: E
•
Calender time counter
•
Operation time counter
•
Gearbox operation time counters
•
Moved distance counter
CAUTION
Resetting counters cannot be undone.
Note
The moved distance value cannot be reset through the service routines.
© Copyright 20192020 ABB. All rights reserved.
6 Programming and testing
6.10.5 Service Information System service routine
165