ABB OmniCore S Series Operating Manual page 58

3 OmniCore controller operating modes
3.3 Locking and unlocking operating modes
Continued
Configuring a permanent PIN-code
A user with the Key-less mode selector grant can configure a permanent PIN-code
for other users to lock the operating mode.
Use the following procedure to configure a permanent PIN-code:
Continues on next page
58
Note
A user with the Key-less mode selector grant can unlock the Lock button at any
time without providing a PIN-code.
1 On the FlexPendant status bar, tap the QuickSet button.
The Control Panel window is displayed.
2 In the Mode section, tap the Lock button.
The Mode Selector PIN-code window is displayed.
xx2000000186
3 Select the Request permanent lock check box.
Note
The Request Permanent lock check box is displayed only for those users
with the Key-less mode selector grant enabled.
4 Tap a 4 digit PIN-code on the number pad.
5 Tap OK.
The permanent PIN-code is saved and is applicable for all the users.
© Copyright 20192020 ABB. All rights reserved.
Operating manual - OmniCore
3HAC065036-001 Revision: E