Creating A Payload - ABB OmniCore S Series Operating Manual

6 Programming and testing

6.8.2 Creating a payload

6.8.2 Creating a payload
What happens when I create a payload?
When you create a payload, a variable of the type loaddata is created. The
variables name will be the name of the payload. For more information on data
types, see Technical reference manual - RAPID Instructions, Functions and Data
types.
Adding a new payload and setting data declaration
The payloads coordinate system will be set to the position, including orientation,
of the world coordinate system.
Payload declaration settings
If you want to change...
the payload's name
Continues on next page
146
1 On the start screen, tap Calibrate, and then select Payload from the menu.
2 Tap Create New Data in the menu to the right.
The Create Payload window is displayed.
3 Complete the payload information (see
page 146) and then tap Apply.
The payload is created.
WARNING
It is important to always define the actual tool load and, when used, the payload
of the robot (for example, a gripped part). Incorrect definitions of load data can
result in overloading of the robot mechanical structure. There is also a risk that
the speed in manual reduced speed mode can be exceeded.
When incorrect load data is specified, it can often lead to the following
consequences:
• The robot may not use its maximum capacity.
• Impaired path accuracy including a risk of overshooting.
• Risk of overloading the mechanical structure.
The controller continuously monitors the load and writes an event log if the load
is higher than expected. This event log is saved and logged in the controller
memory.
© Copyright 20192020 ABB. All rights reserved.
Payload declaration settings on
...then...
enter a name in Name
Recommendation
Payloads are automatically
named load followed by a
running number, for example
load10, load31.
You should change this to
something more descriptive.
If you change the name of a
payload after it is referenced
in any program you must also
change all occurrences of that
payload's name.
Operating manual - OmniCore
3HAC065036-001 Revision: E