ABB OmniCore S Series Operating Manual page 59

Once a permanent PIN-code is enabled, the users must provide the correct PIN-code
to change the operating mode. For more details, see
on page
Unlocking the operating mode
If the operating mode is locked you can unlock it using a temporary or a permanent
PIN-code.
Use the following procedure to unlock:
Operating manual - OmniCore
3HAC065036-001 Revision: E
59.
Note
For permanent PIN-code, after an unlock, if the operating mode is changed, the
mode change will again be locked immediately.
Note
A saved permanent PIN-code is valid until a user with the Key-less mode selector
grant resets the permanent PIN-code.
1 On the FlexPendant status bar, tap the QuickSet button.
The Control Panel window is displayed.
2 In the Mode section, tap the Lock button.
The Mode Selector PIN-code window is displayed.
3 Tap the 4 digit PIN-code on the number pad.
Note
If the permanent PIN-code is enabled, you must provide the PIN-code
configured by the Key-less mode selector grant user.
Note
If you are tapping a temporary PIN-code, you must provide the PIN code
that you have configured using the procedure listed in
temporary PIN-code on page
4 Tap OK.
The operating mode is unlocked.
Note
The temporary PIN-code is reset every time the user unlocks it.
Note
For permanent PIN-code, the users will have one minute time to change the
operating mode before it is locked again.
© Copyright 20192020 ABB. All rights reserved.
3 OmniCore controller operating modes
3.3 Locking and unlocking operating modes
Unlocking the operating mode
57.
Continued
Configuring a
59