ABB OmniCore S Series Operating Manual page 161

Limitations
Besides service routines, Call Routine applies to all routines with the following
criteria:
Operating manual - OmniCore
3HAC065036-001 Revision: E
• Must be a procedure with empty parameter list. This means not a function
and not a trap routine.
• Must be in the task scope, not local. If the procedure is local in a module the
scope is restricted to that module, and the procedure is not visible from the
task level.
• Must be in a loaded module, not installed. (Check the system parameter
Installed in the type Automatic Loading of Modules in the Controller topic.)
© Copyright 20192020 ABB. All rights reserved.
6 Programming and testing
6.10.1 Running a service routine
Continued
161