Ricoh Taurus-C1a Technical Bulletin page 87

Hide thumbs Also See for Taurus-C1a:

Table of Contents

Taurus-C1 / P1

< SC Tables \ SC500: Paper Feed, Transport, Duplexing >

Hot Roller NC Sensor (Sensor 7) Poor Connection

The hot roller NC sensor (infrared thermistor) on top of the fusing unit detected temperature

less than 0C for 75 sec.

Do SP51810 to cancel the fatal error

Sensor disconnected

Sensor connector harness or connector broken or defective

< SC Tables \ SC600: Communications >

@Remote Service ID2 Mismatch Error 1

One of the following problems occurred with ID2 stored in NVRAM:

･ A control board from another machine where Cumin was set up was installed in this

･ NVRAM was replaced with the NVRAM from another machine.

･If Cumin has already been installed, confirm that the NVRAM is compatible for use with

･If Cumin has just been installed, confirm that the NVRAM is compatible for use with

Cumin, clear the Cumin setting, set the common authentication, then try again.

< SC Tables \ SC900: Other >

Operation Panel Management Records Exceeded

An error occurred because the number of records exceeded the limit for images managed in

the service layer of the firmware. This can occur if there if there are too many application

screens open on the operation panel.

･ No action required because this SC does not interfere with operation of the machine.

Chapters

Table of Contents