Ricoh Taurus-C1a Technical Bulletin page 81

Model:
Taurus-C1 / P1
7. Re-attach the top cover [A] (
8. Turn the machine on.
9. Wait a few moments for the pressure roller to move to the start position.
10. Enter the SP mode.
• Switch ON SP5805-102 (Output Check - Press Roller Lift Motor (Up)).
• If you hear no belt noise, or if the belt makes noise and then goes off, switch ON SP5805-101 (Output
Check - Press Roller Lift Motor (HP))
• If the roller noise does not stop, switch ON SP5804-114 (Output Check - Fusing Motor: High Speed)
and with SP5804-114 ON do SP5805-102 and then wait for the noise to stop.
• Once the noise stops, switch SP5805-101 ON, switch SP5804-114 OFF, and then exit the SP mode.
• After doing these SP codes, be sure the remove the cover and reassemble the fusing unit.
< Fusing Unit \ Hot Roller, Fusing Belt \ Cleaning, Lubrication >
The following procedure was deleted as grease application for the Hot Roller Bearings is
unnecessary.
Part Name
Hot Roller Bearings (x2)
3. Use a small brush to apply FLUOTRIBO MG Grease to the ring guides on both ends of the heating roller.
T
echnical
x1, x2).
Interval
650K
B
ulletin
Date:
21-Oct-11
Action
Lubricate
PAGE: 33/58
No.:
RD074026