Ricoh Taurus-C1a Technical Bulletin page 272

Model:
Taurus-C1/P1 (D074/D075/M044)
Action
1. Remove the damaged seal and replace it with a new seal by referring to the table below
which describes the logged SC and the corresponding stations.
Logged SC
SC390 or SC395
SC391 or SC396
SC392 or SC397
SC393 or SC398
NOTE:
Development roller seals should be replaced ONLY for the affected station(s).
For a detailed procedure on development roller seal replacement, see RTB
#RD074063 "Procedure for Replacing the Seals of the Development Roller".
2. Replace the Drum Cleaning Unit with a new one for the affected station that has new
seals attached.
3. Apply lubricant powder (Zinc Stearate Powder; P/N D0159501) on the new development
roller seals and on the corners of the drum cleaning blade. See the related RTB
#RD074071 "SC39X（Drum Motor Error)" for the detailed procedure.
4. Do the following SP for the affected unit to complete the procedure.
SP3032-03: Execute Cleaning Setup: Exe: K
SP3032-04: Execute Cleaning Setup: Exe: C
SP3032-05: Execute Cleaning Setup: Exe: M
SP3032-06: Execute Cleaning Setup: Exe: Y
IMPORTANT: Make sure to completely follow all of the above 4 steps.
T B
echnical
Corresponding Color Station
Replace the seals for the K-Development Unit.
Replace the seals for the C-Development Unit.
Replace the seals for the M-Development Unit.
Replace the seals for the Y-Development Unit.
ulletin
Date:
04-Jun-12
PAGE: 2/2
No.:
RD074072