Ricoh Taurus-C1a Technical Bulletin page 25

Model:
Taurus-C1 (D074/D075)
The following table is an excerpt from the reference table describing the SP codes and the
corresponding PM parts in the section "Preventive Maintenance > PM Tables for Main
Machines > ARDF > SP Setting Summary" of the service manual.
Procedures indicated "Yes" in
Task
1 PM Parts
2 Set Toner Bottle
3 Open Front Doors
4 Main Power ON
5 Enter SP Mode
6 Reset PM Part
7 Install Developer
8 Developer File OK?
9 Apply Lubricant
10 Close Front Door
11 Wait for Warmup ("Ready")
12 Manual Toner Fill
13 Cleaning
14 Initialize TD Sensor
15 Confirm TD Sensor Initialization
16 Initialize Process Control
17 Confirm Process Control Initialization
18 Exit SP Mode
T B
echnical
red in the column "Installation" have been deleted.
Applicable part only
Both left, right doors
Applicable part only
SP3024-001(K)
SP3024-002 (C)
SP3024-003 (M)
SP3024-004 (Y)
SP3025-001
Results for YMCK
reading left to right
1. Open right front door.
2. SP2310-001
3. Close right door.
Wait 5 min. for the
audible beep and the
"Ready" message on
the operation panel.
SP3051-001
SP3032-001 (All)
SP3032-02 (CMY)
SP3032-03 (K)
SP3032-04 (C)
SP3032-05 (M)
SP3032-06 (Y)
SP3030-01 (All)
SP3030-02 (CMY)
SP3030-03 (K)
SP3030-04 (C)
SP3030-05 (M)
SP3030-06 (Y)
SP3031-001
Results for YMCK,
reading left to right.
SP3020-001
SP3012-001
ulletin
Date:
22-Jun-2011
Details Installation
PAGE: 5/14
No.:
RD074015a
‐
Yes
Yes
Yes
Yes
‐
Yes
Yes
‐
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes