Ricoh Taurus-C1a Technical Bulletin page 231

Model:
Taurus-C1/P1 (D074/D075/M044)
1. Input the default values for the following SPs.
NOTE: If the values currently applied are not defaults and need to be changed to carry out this
procedure, make sure to reset them to the original value after completing the procedure.
SP2103-001 (Erase Margin Adj: LE Width)
SP2103-003 (Erase Margin Adj: Left)
SP2122-102 (Erase Margin Adj: LE Plain Weight 2)
2. Set the paper in use in the desired tray and register the paper as Custom Paper.
3. Go into the Advanced Settings and apply the following settings.
13 Adjust Erase Margin of Leading Edge
14 Adjust Erase Margin of Trailing Edge
4. Print 5 copies of the test pattern Trimming Area (SP2109-003-14) in b/w, duplex.
5. Measure the two locations (a) and (b) on all 5 copies and calculate the average of
each.
6. Calculate the values using the following formula.
Leading edge
Side-to-side :
7. Apply the above values to the following settings in the Advanced Settings menu.
8 Adj Image Position of Side 1 With Feed
9 Adj Image Position of Side 2 With Feed
10 Adj Image Position of Side 1 Across Feed
11 Adj Image Position of Side 2 Across Feed
8. Print 5 copies of the test pattern Trimming Area (SP2109-003-14) in b/w, duplex again
to check if the measurement is within the recommended range;
(a)(a'): 2.0 +/- 0.2 mm, (b)(b'): 4.0 +/- 0.2 mm
* If the result is not within the range, repeat steps 4 to 7.
T
echnical
Advanced Settings
: 4.0 – (average (b)) = X
: 4.0 – (average (b')) = X
: 2.0 – (average (a)) = Y
2.0 – (average (a')) = Y
Advanced Settings
B
ulletin
Date:
10-Apr-12
4.0 mm (default)
2.0 mm (default)
0.0 mm (default)
Set to
0
0
1
2
1
2
Set to
X
1
X
2
Y
1
Y
2
PAGE: 12/16
No.:
RD074060