Table of Contents
Advertisement
Model:
Taurus-C1 / P1
< Troubleshooting for Paper Delivery Problems\ Paper Feed Problems Affecting
Image Quality \ Decurling Results in Scratches, Streaks, or Creases >
Before the Revision
Solution:
2. In [Advanced Settings] for the custom paper in
use, adjust the paper feed speed of the decurler
unit.
• If the degree of decurling is set to "Off", reduce the
value in [51: Decurler Feed Speed Adj: Curl Adj
Off] by 0.5%.
• If the degree of decurling is set to "Weak", reduce
the value in [52: Decurler Feed Speed Adj: Curl
Adj Weak] by 0.5%.
• If the degree of decurling is set to "Strong", reduce
the value in [53: Decurler Feed Speed Adj: Curl
Adj Strg] by 0.5%.
< Troubleshooting for Throughput \ Reducing the Waiting Time Prior to Printing >
Before the Revision
1. In the [Adjustment Settings for Skilled Operators]
menu, decrease the temperature by 10°C in
[0206: Adjust Fusing Temperature on Standby].
< Troubleshooting for Throughput \ Throughput When Printing on Paper with a
Thickness Equivalent to Paper Weight 6 or 7 >
Before the Revision
1. In [Advanced Settings] for the custom paper in
use, increase the value in [19: Process Speed
Setting] by one step.
The table below was added.
Advanced Settings
T
echnical
SP Code Settings
High
0: Target Speed
Middle
1: Medium Speed
Low
2: Low Speed
B
ulletin
Date:
21-Oct-11
After the Revision
Solution:
2. In [Advanced Settings] for the custom paper in
use, adjust the paper feed speed of the decurler
unit.
• If the degree of decurling is set to "Off", reduce the
value in [51: Decurler Feed Speed Adj: Curl Adj
Off] by 0.5% or reduce the setting of SP1-959 by
0.5%.
• If the degree of decurling is set to "Weak", reduce
the value in [52: Decurler Feed Speed Adj: Curl
Adj Weak] by 0.5% or reduce the setting of SP1-
960 by 0.5%.
• If the degree of decurling is set to "Strong", reduce
the value in [53: Decurler Feed Speed Adj: Curl
Adj Strg] by 0.5% or reduce the setting of SP1-
961 by 0.5%.
After the Revision
1. In the [Adjustment Settings for Skilled Operators]
menu, decrease the temperature by 10°C in
[0206: Adjust Fusing Temperature on Standby] or
decrease the settings of SP1-107-001, 003, and
007.
After the Revision
1. In [Advanced Settings] for the custom paper in
use, increase the value in [19: Process Speed
Setting] by one step or increase the value of SP1-
986 by 1 step.
The settings for the Advanced Settings and the
SP settings correspond to one another as shown
in the table below.
PAGE: 52/58
No.:
RD074026
Advertisement
Chapters
Table of Contents
